GreenFiber Wall Insulation Nationwide

GreenFiber Wall Insulation in Boerne: What to Know First

We provide independent GreenFiber wall insulation service in Boerne, typically turning around standard jobs in one to two days and always delivering a written price before any work starts. Most GreenFiber wall insulation projects in the Hill Country run between $2,800 and $5,400 depending on wall area, cavity condition, and whether we’re drilling and filling from the exterior or accessing through interior drywall. This page is for homeowners who already have GreenFiber insulation in their walls and need it assessed, supplemented, or replaced by technicians who understand how this cellulose-based product behaves in our specific climate. Call (830) 529-7780 to schedule a free estimate with a written scope.

Call (830) 529-7780

How GreenFiber Products Fail - and How We Fix Them

• GreenFiber All Borate Cellulose settling in tall wall cavities. In Boerne’s older two-story homes near Main Street, we’ve measured 30% settlement in 9-foot and taller studs after eight to twelve years. The material compacts under its own weight, leaving a thermal bypass at the top plate. We remove the settled pack through exterior drill-and-fill access points, then reinstall at proper density with supplemental netting where cavity height exceeds 96 inches.
• GreenFiber Sanctuary blown-in insulation absorbing seasonal humidity. This product line’s high borate content resists fire and pests, but in the Hill Country’s spring humidity swings, we’ve found it can hold moisture against OSB sheathing in walls with inadequate exterior drainage planes. We test with a moisture meter before blowing, and if readings exceed 18%, we air seal and ventilate the cavity before adding any new material.
• GreenFiber Low Dust formulation bridging around electrical boxes. The low-dust additive reduces airborne particles during installation, but in retrofit applications it can clump around plastic gang boxes and create voids. Our crews use a paddle bit to clear a 4-inch radius around each box, then dense-pack the surrounding cavity to maintain continuity.
• GreenFiber stabilized cellulose losing adhesive bond in freeze-thaw cycles. Boerne’s occasional hard freezes followed by rapid January thaws can break down the water-soluble binders in stabilized products installed in the 2015-2019 window. We identify this by tapping for hollow spots; affected cavities get full removal and replacement with loose-fill at 3.5 pounds per cubic foot minimum density.
• GreenFiber wall insulation compromised by rodent nesting. Cellulose is treated with borates, not a physical barrier. In homes backing up to the Cibolo Creek greenbelt, we’ve pulled out compacted tunnels where roof rats have used the insulation as bedding. We extract the contaminated material, sanitize the cavity, install rodent-proofing at penetrations, then repack with fresh GreenFiber or shift to mineral wool if recurrence risk is high.

Our GreenFiber Wall Insulation Process

1. 1
   Call and scope. A live person answers at (830) 529-7780. We schedule a site visit, and under Haven Standard Clause 1, you’ll receive a written price, scope, and warranty before any work starts.
2. 2
   Blower-door test and infrared survey. We pressurize the house to measure baseline air leakage in CFM50, then run a thermal camera to locate voids, settlement gaps, and moisture anomalies in the wall plane. You get these images in your Documented Photo Record.
3. 3
   Air sealing before insulation. Seal the envelope first. Then fill it. We seal top plates, electrical penetrations, and window rough openings with acoustic sealant and fire-rated foam. No GreenFiber goes in until the pressure boundary is continuous.
4. 4
   Access decision and material selection. For exterior drill-and-fill, we match siding texture and paint. For interior work, we coordinate drywall repair. We stock GreenFiber All Borate and can source Sanctuary or Low Dust by request; we also keep Reflectix on the truck for radiant barrier pairing where walls see direct western sun.
5. 5
   Installation and density verification. We dense-pack to 3.5 PCF minimum, verifying with cavity-fill calculations and spot-check core samples. The blower-door test runs again immediately after.
6. 6
   Documentation and closeout. You receive the before-and-after blower-door numbers in pascals, the photo record, and the written warranty under our 365-Day Done Right Promise. Payment is due only after you have all three documents in hand.

What GreenFiber Wall Insulation Costs in Boerne

These are real ranges from jobs we’ve completed in Boerne and Fair Oaks Ranch. Your written estimate will specify the exact square footage, material line, and labor hours. We also offer a Free Second Opinion on any written estimate you’ve already received - bring us the competing quote and we’ll read it with you line by line. Call (830) 529-7780 to schedule.

Why Boerne Homeowners Call Topside Attic Insulation Boerne for GreenFiber Work

We’ve sealed and insulated more than 9,000 homes since 2016, and the ones in Boerne present a specific challenge: stack-effect air leakage in the Hill Country’s mixed-humidity climate pulls conditioned air through wall cavities year-round, which means insulation performance depends entirely on what happened before the material went in. Wes Okafor learned this firsthand in the building technology program at Olive-Harvey College and has spent eighteen years refining the sequence. Our crews don’t blow GreenFiber over unsealed top plates. We publish blower-door numbers on every job. The 365-Day Done Right Promise is in writing before anyone lifts a tool. And because we stock Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber - plus Reflectix for radiant applications - we recommend what fits your wall assembly, not what moves our inventory.

FAQs